1. Carbon dioxide gas to produce laser cutting laser cutting, stitching is out of shape not easily machined part: by carbon dioxide laser gas production of a laser beam is a continuous, very small points of light, these smaller beam has a great deal of heat energy, can rapid heating processing parts make its evaporation evaporation are formed, the laser spot as the design requirements of the linear moving, mechanical parts forming holes and cutting seam small trimming, usually only 0.1 ~ 0.5 mm. Depending on different materials, oxygen or nitrogen is generally used as the auxiliary gas for laser cutting. Laser cutting quality is far better than acetylene flame cutting, acetylene flame cutting slit may be up to 20mm.

2. The laser cutting produced by carbon dioxide laser gas has no contact with the workpiece: since the laser cutting produced by carbon dioxide laser gas cuts the workpiece through the laser beam, the laser cutting has no direct contact with the workpiece, so there is no deformation caused by mechanical extrusion of the workpiece. Because laser cutting does not use oil cooling or water cooling, the workpiece is very clean and does not need any cleaning treatment after cutting.

3. The laser cutting produced by carbon dioxide laser gas is very flexible: compared with the punching die, laser cutting can process very complex workpiece. There is no need to make a new mold for the processing of different workpiece.